SuperATV Honda Rubicon 4" Portal Gear Lift

Features:

Available with billet or cast aluminum housing
Cool, quiet, precision-ground gears made from 9310 alloy billet steel
1.5 in. diameter 4340 hardened steel drive shaft
Housings use gaskets or O-rings that don’t let anything through
Universal hub fits all major bolt patterns
Gear reduction reduces stress on your drivetrain
Lighter than the competition

Wheel Requirements
14” or larger wheel required
Cannot exceed 5” backspacing
Not compatible with dual beadlock wheels
Wheels need to have a center hole of at least 3.25" (82.55mm) or require a 1” wheel spacer

Max Tire Sizes for Portal Gear Lift

Max tire sizes are measured at full compression and full turn. The given tires sizes are the largest we fit without rubbing. With minor trimming or a small amount of rub, larger tire sizes can be used.

Dominate Any Trail with Honda Rubicon GDP Portals

Your Honda Rubicon is a beast, but why not make it unstoppable? SuperATV’s 4” GDP Portal Gear Lift gives you the power, clearance, and durability to conquer any terrain. You get power and performance thanks to the lift and gear reduction built into the hub. And with your choice of a 15% or 30% gear reduction, you get the perfect balance of torque and speed. With GDP Portals, you’ll be ready for anything.

Get the Power You Need

With two gear reduction options, you’re in control. A 30% reduction delivers max torque for hauling heavy loads and powering through deep mud. Stick with 15% if you want a speed-friendly setup while still getting that extra boost in torque.

Drivetrain Protection Built In

More power doesn’t have to mean more wear. GDP Portals put the gear reduction in the hub, which means your drivetrain stays protected. Plus, the suspension maintains factory geometry, so your axles run cooler. Plus, the gear reduction goes in the hub, so your axles, differential, and transmission all benefit from it and wear less.

Stronger, Smarter, Tougher

We don’t cut corners—our portals are built to last. Your choice of cast or 6061 billet aluminum housings, combined with Advanced steel backing plates, make them tough enough for anything the trail throws at you.

Our housings are reinforced for gear retention and optimized for oil flow
Advanced steel alloy backing plates are stronger than chromoly
Enhance with Portal Blood—gear oil formulated for GDP Portals
There are no gimmicks and no vents because vents do more harm than good—we know because we tested them

Advanced Gaskets, Seals, and Bearings

Our portals use:

Advanced gaskets and O-rings with excellent oil resistance and low deterioration rates
A sealed input gear and double-lipped output seal
100% sealing coverage throughout so you can forget about oil leaks
Double-angular contact output bearings to prevent premature wear
Roller idler and drive bearings to maintain perfect gear meshing

Top-Rated Customer Service

Still not sure exactly what you need? We’ve got a dedicated team to help you make the right choice. Give us a call so we can get the perfect set of portals in your hands today.

4” Portal Gear Lift Includes:

(4) Assembled portal hub boxes complete with 9310 gears, seals, output shaft, gaskets, and thrust bearings

(4) Universal hubs and precision-ground stainless steel slotted rotors with lugs

(4) Specialized steel alloy backing plates

(2) Steel caliper mounting plates

(2) Caliper mounting plate shims

Extended brake lines

All required hardware, including recessed castle nut socket