NOTE: This portal kit requires the use of SATV rear trailing arms

Wheel Requirements:

18” or larger wheel required

18” wheels cannot exceed 4-1/2” backspacing

20” wheels cannot exceed 5” backspacing

Wheels need to have a center hole of at least 3.25" (82.55mm) or require a 1” wheel spacer

Features:

• Available with billet or cast aluminum housing
• 9310 alloy billet steel precision ground gears are cool and quiet
• Increases width by 4 in. per side (8 in. total)
• 1.5 in. diameter 4340 hardened steel drive shaft
• No leak bearings and seals
• Universal hub fits all major bolt patterns
• Comes complete with all hardware, backing plates, brakes lines and instructions 

Gen 3 Portals are Geared for All

• Our housings are reinforced in all the right places
• They’re built with better oil flow and gearing forces in mind
• There are no gimmicks and no vents because vents do more harm than good—we know because we tested them

• Advanced gaskets with excellent oil resistance and a lower deterioration rate than Kevlar gaskets
• A sealed input gear and double-lipped output seal
• 100% sealing coverage throughout so you can forget about oil leaks

• (4) Assembled portal hub complete with 9310 gears, seals, output shaft, advanced, and thrust bearings
• (4) Universal hubs and stainless steel slotted rotors with ith lugs
• (4) Specialized steel alloy backing plates
• (3) Steel caliper mounting plates
• (3) Caliper mounting plate shims
• (2) Steel steering arms
• (2) Extended Trailing arms (only if SATV trailing arms are not already installed)
• Extended brake lines
• All required hardware, including recessed castle nut socket
•